Agilent Technologies N5171B

Agilent X-Series Signal Generators SCPI Command Reference 231
Analog Modulation Commands
Phase Modulation Subsystem–Option UNT ([:SOURce])
[:SOURce]:PM[1]|2:INTernal:NOISe[1]|2:TYPe?
This command sets the noise type when “:PM[1]|2:SOURce” on page 235 is set to NOISe[1] or
NOISe2.
*RST POS
:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt
Supported All models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt <val><units>
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt?
This command sets the start frequency for the swept function generator.
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry M Start Freq
:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP
Supported All models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP <val><units>
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP?
This command sets the stop frequency for the swept function generator.
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry M Stop Freq
:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe
Supported All Models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe SINE|TRIangle|SQUare|RAMP
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe?
This command sets the phase modulation waveform type for the swept function generator.
*RST SINE
:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP
Supported All Models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP POSitive|NEGative
[:SOURce]:PM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP?
Key Entry Noise Gen 1 Noise Gen 2
Key Entry
M Sweep Waveform