192 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Trigger Subsystem
:TRIGger[:SEQuence][:IMMediate]
Supported All Models
:TRIGger[:SEQuence][:IMMediate]
This event command causes an armed List or Step sweep to immediately start without the selected
trigger occurring.
:TSWeep
Supported All Models
[:SOURce]:TSWeep
This command aborts the current sweep, then either arms or arms and starts a single list, depending
on the trigger type.
The command performs the following:
• arms a single sweep when BUS, EXTernal, or Trigger KEY is the trigger source selection
• arms and starts a single sweep when IMMediate is the trigger source selection
Key Entry Single Sweep
To Next Page
Loading...