To Next Page

To Previous Page

Agilent X-Series Signal Generators SCPI Command Reference 221

Analog Modulation Commands

Low Frequency Output Subsystem ([:SOURce]:LFOutput)

This command sets the noise type when :SOURce is set to NOISe[1] or NOISe2.

*RST POS

:OFFset

Supported All Models with Option UNT

[:SOURce]:LFOutput:OFFset <value><unit>

[:SOURce]:LFOutput:OFFset?

This command sets the DC offset (in volts) of the signal at the LF Output connector.

*RST 0.000 V

:SOURce

Supported All Models with Options UNT and 303

[:SOURce]:LFOutput:SOURce?

This command selects the source for the LF output.

MONitor Selects monitoring on the LF output BNC. Select the monitoring source using the

:SOURce:MONitor command.

FUNCtion[1] Selects function generator 1 as the modulation source.

FUNCtion[2] Selects function generator 2 as the modulation source.

SWEep Selects the swept function generator as the LF output BNC source. If AM or FM or

PM is modulating the swept function generator then the LF output BNC will have

the unmodulated signal if you choose to monitor the swept function generator.

DUAL Selects the dual function generator as the modulation source.

NOISe[1] Selects noise generator 1 as the modulation source.

NOISe2 Selects noise generator 2 as the modulation source.

DC Selects a DC voltage level as the LF output BNC source.

*RST MONitor

Remarks Only MON, FUNC1 and DC are available without Option 303.

:SOURce:MONitor

Supported All models with Option UNT

[:SOURce]:LFOutput:SOURce:MONitor FUNCtion[1]|FUNCtion2|SWEep|DUAL

Key Entry Uniform Gaussian

Range - 10.000 to 10.000 V

Key Entry LF Out DC Offset Into 50 Ohms LF Out DC Offset Into 1 MOhms

Key Entry Int Monitor Func Gen 1 Dual Func Gen Noise Gen 1

DC Func Gen 2 Swept Func Gen Noise Gen 2

Agilent Technologies N5171B User Manual

Questions and Answers: