Agilent Technologies N5171B

384 Agilent X-Series Signal Generators SCPI Command Reference
Real–Time Commands
Custom Subsystem–Option 431([:SOURce]:RADio:CUSTom)
:BURSt:SHAPe:RDELay
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RDELay <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RDELay?
This command sets the burst shape rise delay.
The variable <val> is expressed in bits.
*RST
+0.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Rise Delay
Remarks
To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:RISE:DELay” on page 384 performs the same function; in
compliance with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe:RISE:DELay
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RISE:DELay <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RISE:DELay?
This command sets the burst shape rise delay.
The variable <val> is expressed in bits.
*RST
+0.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Rise Delay
Remarks To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:RDELay” on page 384 performs the same function; in compliance
with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe:RISE:TIME
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RISE:TIME <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RISE:TIME?