Agilent X-Series Signal Generators SCPI Command Reference 43
Basic Function Commands
Frequency Subsystem ([:SOURce])
Remarks To set the frequency mode to FIXed, refer to :FREQuency:MODE.
A frequency change may affect the current output power. Refer to
[:LEVel][:IMMediate][:AMPLitude] for the correct specified frequency and
amplitude settings.
:FREQuency:LSPurs:STATe
Supported All Models
[:SOURce]:FREQuency:LSPurs:STATe ON|OFF|1|0
[:SOURce]:FREQuency:LSPurs:STATe?
This command enables the mode to improve non- harmonics performance (low spurs mode). Enabling
this mode affects switching speed.
1 This choice enables the mode to improve non- harmonics.
0 This choice disables the mode to improve non- harmonics.
*RST 0
Key Entry Improve non- harmonics
:FREQuency:MODE
Supported All Models
[:SOURce]:FREQuency:MODE CW|FIXed|LIST
[:SOURce]:FREQuency:MODE?
This command sets the frequency mode of the signal generator to CW or swept.
CW and FIXed These choices are synonymous with one another and stops a frequency sweep,
allowing the Agilent MXG to operate at a set frequency. Refer to the
:FREQuency[:CW] command for setting the frequency in the CW mode and to the
:FREQuency:FIXed command for setting the frequency in the FIXed mode.
LIST This choice selects the swept frequency mode. If sweep triggering is set to
immediate along with continuous sweep mode, executing the command starts the
LIST or STEP frequency sweep.
Option 503: +30000000000000E+09
Option 506: +60000000000000E+09
Range Option 501: 9kHz–1GHz
Option 503: 9kHz–3GHz
Option 506: 9kHz–6GHz
To Next Page
Loading...
Need help?
General
