158 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Status Subsystem (:STATus)
:QUEStionable:FREQuency:NTRansition
Supported All Models
:STATus:QUEStionable:FREQuency:NTRansition <value>
:STATus:QUEStionable:FREQuency:NTRansition?
This command determines which bits in the Data Questionable Frequency Condition Register will set
the corresponding bit in the Data Questionable Frequency Event Register when that bit has a
negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:FREQuency:PTRansition
Supported All Models
:STATus:QUEStionable:FREQuency:PTRansition <value>
:STATus:QUEStionable:FREQuency:PTRansition?
This command determines which bits in the Data Questionable Frequency Condition Register will set
the corresponding bit in the Data Questionable Frequency Event Register when that bit has a positive
transition (0 to 1).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:FREQuency[:EVENt]?
Supported All Models
CAUTION This is a destructive read. The data in the register is latched until it is queried. Once
queried, the data is cleared.
:STATus:QUEStionable:FREQuency[:EVENt]?
This query returns the decimal sum of the bits in the Data Questionable Frequency Event Register.
Range 0 to 32767
Remarks The equivalent PTR or NTR filters must be set before the condition register can
set the corresponding bit in the event register.
Refer to the Programming Guide for more information.
To Next Page
Loading...
Need help?
General
