Agilent Technologies N5171B User Manual

328 Agilent X-Series Signal Generators SCPI Command Reference
Arb Commands
Two Tone Subsystem–N5172B/82B ([:SOURce]:RADio:TTONe:ARB)
Two Tone Subsystem–N5172B/82B ([:SOURce]:RADio:TTONe:ARB)
:ALIGnment
Supported N5172B/82B
[:SOURce]:RADio:TTONe:ARB:ALIGnment LEFT|CENTer|RIGHt
[:SOURce]:RADio:TTONe:ARB:ALIGnment?
This command will align the two tones either left, center or right of the carrier frequency.
Example
:RAD:TTON:ARB:ALIG CENT
The preceding example aligns each of the two tones equidistant from the carrier frequency.
Key Entry Alignment Left Cent Right
:APPly
Supported N5172B/82B
[:SOURce]:RADio:TTONe:ARB:APPLy
This command will cause the two–tone waveform to be regenerated using the current settings.
This command has no effect unless the two–tone waveform generator is enabled and a change has
been made to the frequency spacing setting.
Key Entry Apply Settings
:BASEband:FREQuency:OFFSet
Supported N5172B/82B
[:SOURce]:RADio:TTONe:ARB:BASeband:FREQuency:OFFSet <val><unit>
[:SOURce]:RADio:TTONe:ARB:BASeband:FREQuency:OFFSet?
This command offsets the baseband frequency relative to the carrier. The feature is useful for moving
the signal such that the carrier feed–through is not in the center.
The X- Series signal generator provides automatic DAC over–range protection when the offset value is
something other than 0 Hz. It scales down the playing I/Q data by 1/square root of 2.
*RST 0 Hz
Range +5.0E7 to –5.0E7 MHz
Key Entry Baseband Frequency Offset
:BASeband:FREQuency:OFFSet:PHASe:RESet
Supported N5172B/82B
[:SOURce]:RADio:TTONe:ARB:BASeband:FREQuency:OFFSet:PHASe:RESet
This command clears the phase accumulation and so zero phase shift.

Agilent Technologies N5171B Specifications

General

Brand	Agilent Technologies
Model	N5171B
Category	Computer Hardware
Language	English