Agilent X-Series Signal Generators SCPI Command Reference 91
Basic Function Commands
Vector Modulation Subsystem—N5172B/82B ([:SOURce]:IQ)
FREE With this choice, the signal will flow freely through the output channel.
TRIGger With this choice, the output will start after a trigger is received.
*RST FREE
:OUTPut[1]:TRIGger:EXTernal:DELay
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:DELay <value>
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:DELay?
This command adds an external trigger delay (in seconds). The value you enter sets a delay time
between when an external trigger is received and when it is applied to the signal.
This key is active only if you select external (Ext) as the trigger source.
*RST 0 ns
Range 0 ns to 41 s
Key Entry Ext Delay Time
:OUTPut[1]:TRIGger:EXTernal:POLarity
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:POLarity POSitive|NEGative
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:POLarity?
This command sets the polarity of the external trigger source to trigger on a positive edge or negative
edge.
*RST POS
Key Entry Ext Polarity Neg Pos
:OUTPut[1]:TRIGger:EXTernal:SOURce
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:SOURce EPTRigger[1]|EPTRigger2
[:SOURce]:IQ:OUTPut[1]:TRIGger:EXTernal:SOURce?
Selects the trigger source for the external trigger.
EPTRigger1 This choice selects the PATT TRIG IN 1 rear panel connector (AUX I/O) as the
external trigger source.
EPTRigger2 This choice selects the PATT TRIG IN 2 rear panel connector (AUX I/O) as the
external trigger source.
*RST EPTRigger1
Key Entry Ext Source
Key Entry Free Run Trigger and Run
To Next Page
Loading...
Need help?
General
