154 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Status Subsystem (:STATus)
:OPERation:PTRansition
Supported All Models
:STATus:OPERation:PTRansition <value>
:STATus:OPERation:PTRansition?
This command determines which bits in the Standard Operation Condition Register will set the
corresponding bit in the Standard Operation Event Register when that bit has a positive transition (0
to 1).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
:OPERation:SUPPress
Supported All Models
:STATus:OPERation:SUPPress 0|1|ON|OFF
:STATus:OPERation:SUPPress?
This command disables the instrument’s management of the Standard Operation Condition Register
and saves 50 us of switching time.
*RST OFF
Remarks Refer to the Programming Guide for more information.
:OPERation[:EVENt]
Supported All Models
CAUTION This is a destructive read. The data in the register is latched until it is queried. Once
queried, the data is cleared.
:STATus:OPERation[:EVENt]?
This query returns the decimal sum of the bits in the Standard Operation Event Register.
Range 0 to 32767
Remarks The equivalent PTR or NTR filters must be set before the condition register can
set the corresponding bit in the event register.
Refer to the Programming Guide for more information.
:PRESet
Supported All Models
:STATus:PRESet
This command presets all transition filters, enable registers, and error/event queue enable registers.
Remarks Refer to the Programming Guide for more information.
To Next Page
Loading...
Need help?
General
