Agilent X-Series Signal Generators SCPI Command Reference 385
Real–Time Commands
Custom Subsystem–Option 431([:SOURce]:RADio:CUSTom)
This command sets the burst shape rise time.
The variable <val> is expressed in bits.
*RST
+5.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Rise Time
Remarks To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:RTIMe” on page 385 performs the same function; in compliance
with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe:RTIMe
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RTIMe <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:RTIMe?
This command sets the burst shape rise time.
The variable <val> is expressed in bits.
*RST
+5.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Rise Time
Remarks
To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:RISE:TIME” on page 384 performs the same function; in
compliance with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe[:TYPE]
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe[:TYPE] SINE|"<file name>"
[:SOURce]:RADio:CUSTom:BURSt:SHAPe[:TYPE]?
This command specifies the burst shape ("<file name>").
SINE This choice selects a burst shape that is defined by the burst rise and fall *RST values,
as the default burst shape type.
"<file name>" This choice selects a user designated file from signal generator memory (non-volatile).
To Next Page
Loading...