Agilent Technologies N5171B

Agilent X-Series Signal Generators SCPI Command Reference 103
System Commands
Communication Subsystem (:SYSTem:COMMunicate)
:LAN:IDENtify
Supported All Models
:SYSTem:COMMunicate:LAN:IDENtify ON|OFF|1|0
This command controls the LAN identify feature.
ON (1) The command enables device identification by displaying the full–screen message
"Identify: <IP Address>" on the signal generator's front panel; the LAN Status
indicator will also show "IDENTIFY". For more information, refer to the
Programming Guide.
OFF (0) This command disables device identification by clearing the message on the signal
generator's front panel and returning the LAN Status indicator to display the
current network state. For more information, refer to the Programming Guide.
:LAN:IP
Supported All Models
:SYSTem:COMMunicate:LAN:IP "<ipstring>"
:SYSTem:COMMunicate:LAN:IP?
This command sets the signal generator’s local area network (LAN) internet protocol (IP) address for
your IP network connection.
Key Entry IP Address
:LAN:MDNS
Supported All Models
:SYSTem:COMMunicate:LAN:MDNS ON|OFF|1|0
:SYSTem:COMMunicate:LAN:MDNS?
This command enables or disables the multicast (mDNS) and DNS service discovery (DNS- SD)
services. The query returns the current setting.
Default On
Key Entry mDNS/DNS-SD Off On
Key Path Utility > I/O Config > LAN Setup > Advanced Settings > Dynamic Hostname Services >
mDNS/DNS-SD Off On