230 Agilent X-Series Signal Generators SCPI Command Reference
Analog Modulation Commands
Phase Modulation Subsystem–Option UNT ([:SOURce])
• the frequency rate for all other waveforms
*RST +4.00000000E+002
:PM[1]|2:INTernal:FUNCtion[1]|2:POFFset
Supported All Models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:POFFset <value><unit>
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:POFFset?
This command sets the phase offset in degrees or radians of internal function generator source.
*RST 0.000 rad
:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe
Supported All Models with Option UNT
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe SINE|SQUare|TRIangle|RAMP|PULSe
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe?
This command sets the phase modulation waveform type.
*RST SINE
Remarks The waveform selection is only valid when INT is the source selection. Refer to
“:PM[1]|2:SOURce” on page 235 for source type selection.
SINE is the only shape available without Option 303.
:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP
Supported All Models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP POSitive|NEGative
[:SOURce]:PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP?
This command sets the ramp direction when :PM[1]|2:INTernal:FUNCtion[1]|2:SHAPe is set to RAMP.
*RST POS
:PM[1]|2:INTernal:NOISe[1]|2:TYPe
Supported All Models with Option UNT and 303
[:SOURce]:PM[1]|2:INTernal:NOISe[1]|2:TYPe UNIForm|GAUSsian
Range All Waveforms: 0.1 Hz–2 MHz (Wideband)All Waveforms: 0.1 Hz–1 MHz (narrowband)
Key Entry M Rate
Range - 6.290 to 6.290 rad
- 360.4 to 360.4 deg
Key Entry
M Phase Offset
Key Entry Pos Ramp Neg Ramp
To Next Page
Loading...
Need help?
General
