Agilent X-Series Signal Generators SCPI Command Reference 141
System Commands
Memory Subsystem (:MEMory)
:LOAD:PTRain
Supported All with Option 320 and either UNU or UNW
:MMEMory:LOAD:PTRain <"filename">
This command reads the pulse train file specified. Refer to :STORe:PTRain.
Key Entry Confirm Load from File
:LOAD:WFM:ALL
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:MMEMory:LOAD:WFM:ALL
This command loads all of the waveforms in the active media to the internal BBG memory. The
active media is either internal non- volatile memory storage media or an external storage media
connected to the front-panel USB port.
Key Entry Load All From Int Media
:MOVE
Supported All Models
:MMEMory:MOVE "<src_file>","<dest_file>"
This command renames the requested file in the memory catalog.
Key Entry Rename File
Remarks Refer to File Name Variables for information on the file name syntax.
:STORe:LIST
Supported All Models
:MMEMory:STORe:LIST "<file name>"
This command stores the current list sweep data to a file.
Key Entry Store To File
:STORe:PTRain
Supported All with Option 320 and either UNU or UNW
:MMEMory:STORe:PTRain <"filename">
Writes out the current pulse train list to the PTRAIN file specified. This operation will overwrite any
existing file of the same name in the PTRAIN directory with a binary file. Refer to :LOAD:PTRain.
Key Entry Store To File
To Next Page
Loading...