Agilent X-Series Signal Generators SCPI Command Reference 135
System Commands
Memory Subsystem (:MEMory)
:DELete:UFLT
Supported All Models
:MEMory:DELete:UFLT
This command deletes all user–flatness correction files.
Key Entry Delete All UFLT Files
:DELete[:NAME]
Supported All Models
:MEMory:DELete[:NAME] "<file name>"
This command clears the user file system of "<file name>".
Key Entry Delete File
Remarks Refer to File Name Variables for information on the file name syntax.
When deleting a waveform (WFM1) file from memory, the marker file and file
header, associated with the waveform file, will also be deleted.
:EXPort[:ASCii]:PTRain
Supported All with Option 320 and either UNU or UNW
:MEMory:EXPort[:ASCii]:PTRAin <"filename">
This command writes out a CSV/ASCII file to the BINARY directory. User may supply their own
extender as part of the filename. Refer to :EXPort[:ASCii]:SEParator:COLumn and
:EXPort[:ASCii]:SEParator:DECimal.
Example
:MEM:EXP:PTR "myfile.csv"
The preceding example saves a power train file to “myfile.csv”.
Key Entry Export To File
:EXPort[:ASCii]:SEParator:COLumn
Supported All with Option 320 and either UNU or UNW
:MEMory:EXPort[:ASCii]:SEParator:COLumn TAB|SEMicolon|COMMa|SPACe
:MEMory:EXPort[:ASCii]:SEParator:COLumn?
This command selects whether the column separator is a tab, ";", "," or a " " during export of
CSV/ASCII files.
This value is persistent across preset/recall and power cycles. (At the factory the MXG is set to
COMMa (“,”).) Refer to :EXPort[:ASCii]:SEParator:DECimal.
Key Entry Export Column Separator
To Next Page
Loading...