140 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Memory Subsystem (:MEMory)
:HEADer:CLEar
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:MMEMory:HEADer:CLEar "<file name>"
This command sets the file header field settings to unspecified for the "<file name>" variable.
Key Entry Clear Header
Remarks In addition to waveforms currently running in the signal generator, it is possible
to change or delete file header information on files that are not currently running
but are stored in either the internal storage or USB media non–volatile memory
(Example: :MMEMory:HEADer:CLEar "NVWFM:file_name").
Refer to File Name Variables for information on the file name syntax.
:HEADer:DESCription
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:MMEMory:HEADer:DESCription "<file name>","<description>"
:MMEMory:HEADer:DESCription? "<file name>"
This command inserts a description for the file header.
Key Entry Edit Description
Remarks In addition to waveforms currently running in the signal generator, it is possible
to change or delete file header information on files that are not currently running
but are stored in either the internal storage or USB media non–volatile memory
(Example: :MMEMory:HEADer:DESCription
"NVWFM:file_name",”example_file_name”).
The header description is limited to 32 characters. Refer to File Name Variables
for information on the file name syntax.
:HEADer:ID?
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:MMEMory:HEADer:ID? "<file name>"
This query returns the unique waveform ID of file
"<file name>"
.
The command is ignored if the file name does not exist.
:LOAD:LIST
Supported All Models
:MMEMory:LOAD:LIST "<file name>"
This command loads a List sweep file.
Key Entry Load From Selected File
To Next Page
Loading...
Need help?
General
