104 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Communication Subsystem (:SYSTem:COMMunicate)
:LAN:RESTart
Supported All Models
:SYSTem:COMMunicate:LAN:RESTart
This command restarts the network to enable changes that have been made to the LAN setup.
Key Entry Proceed With Reconfiguration
Key Path Utility I/O Config Lan Setup Proceed With Reconfiguration
:LAN:SUBNet
Supported All Models
:SYSTem:COMMunicate:LAN:SUBNet "<ipstring>"
:SYSTem:COMMunicate:LAN:SUBNet?
This command sets the signal generator’s local area network (LAN) subnet mask address for your
internet protocol (IP) network connection.
NOTE An error will occur if the IP address, Gateway, and subnet mask have conflicting settings.
Key Entry Subnet Mask
Remarks The SCPI query returns the current setting, not the saved setting.
To Next Page
Loading...