Agilent X-Series Signal Generators SCPI Command Reference 155
System Commands
Status Subsystem (:STATus)
:QUEStionable:CALibration:CONDition?
Supported All Models
:STATus:QUEStionable:CALibration:CONDition?
This query returns the decimal sum of the bits in the Data Questionable Calibration Condition
Register.
Range 0 to 32767
Remarks The data in this register is continuously updated and reflects the current
conditions.
Refer to the Programming Guide for more information.
:QUEStionable:CALibration:ENABle
Supported All Models
:STATus:QUEStionable:CALibration:ENABle <value>
:STATus:QUEStionable:CALibration:ENABle?
This command determines which bits in the Data Questionable Calibration Event Register will set the
calibration summary bit (bit 8) in the Data Questionable Condition Register.
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
:QUEStionable:CALibration:NTRansition
Supported All Models
:STATus:QUEStionable:CALibration:NTRansition <value>
:STATus:QUEStionable:CALibration:NTRansition?
This command determines which bits in the Data Questionable Calibration Condition Register will set
the corresponding bit in the Data Questionable Calibration Event Register when that bit has a
negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want to enable.
Range 0 to 32767
Remarks Refer to the Programming Guide for more information.
To Next Page
Loading...