174 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
:PMETer[1]|2:CHANnel
Supported All Models
:SYSTem:PMETer[1]|2:CHANnel A|B
:SYSTem:PMETer[1]|2:CHANnel?
This command selects the external power meter channel that will be used by each channel’s power
meter measurement. The query returns the selected channel.
Key Entry External Power Meter Channel A B
Default Channel A
:PMETer[1]|2:COMMunicate:LAN:DEVice
Supported All Models
:SYSTem:PMETer[1]|2:COMMunicate:LAN:DEVice <deviceName>
:SYSTem:PMETer[1]|2:COMMunicate:LAN:DEVice?
This command enters a VXI–11 name for a power meter that is being controlled by the signal
generator for power meter measurements. If connecting directly to the power meter enter the name
as specified on your power meter documentation. If connecting through a LAN–GPIB gateway, enter
the SICL address of the power meter.
Key Entry PM VXI–11 Device Name
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:PMETer[1]|2:COMMunicate:LAN:IP
Supported All Models
:SYSTem:PMETer[1]|2:COMMunicate:LAN:IP <ipAddress>
:SYSTem:PMETer[1]|2:COMMunicate:LAN:IP?
This command sets the internet protocol (IP) address for a power meter that is controlled by the
signal generator for power meter measurements. If connecting to a GPIB power meter through a
LAN–GPIB gateway, this command sets the IP address of the gateway.
Key Entry Power Meter IP Address
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
Ensure that the power meter IP address is different from the signal generator
address.
To Next Page
Loading...