To Next Page

To Previous Page

202 Agilent X-Series Signal Generators SCPI Command Reference

Analog Modulation Commands

Amplitude Modulation Subsystem–Option UNT ([:SOURce])

This command sets the couplings between start- to- stop values and stop-to- start values for AM sweep

times and rates. The sweep times coupled to on.

Use this command when :AM[1]|2:INTernal:SWEep:SHAPe is set to TRIangle.

ON|1 This choice uses the same sweep time for both start freq to stop freq and stop

freq to start freq sweeps of a triangle shape sweep. If sweep times coupled is ON,

sweep time and rate is only set by the Start -> Stop softkeys.

OFF|0 This choice disables sweep time couplings.

*RST OFF

:AM[1]|2:INTernal:SWEep:TIME[1]|2

Supported All Models with Options UNT and 303

[:SOURce]:AM[1]|2:INTernal:SWEep:TIME[1]|2 <val><unit>

[:SOURce]:AM[1]|2:INTernal:SWEep:TIME[1]|2?

This command sets the sweep rate for the amplitude- modulated, swept- sine waveform.

*RST

+1.00000000E001

Range 1mS–65.535S

Key Entry AM Sweep Time

:AM[1]|2:INTernal:SWEep:TRIGger

Supported All Models with Options UNT and 303

[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger?

This command sets the trigger source for the amplitude modulated swept- sine waveform.

BUS This choice enables GPIB triggering using the *TRG or GET command or LAN and

RS- 232 triggering using the *TRG command.

IMMediate

This choice enables immediate triggering of the sweep event.

EXTernal This choice enables the triggering of a sweep event by an externally applied signal at the

TRIG 1, TRIG 2, or PULSE BNC connector.

INTernal This choice enables the triggering of a sweep event by an internal Pulse Video or Pulse

Sync signal.

KEY This choice enables triggering through front panel interaction by pressing the

Trigger hardkey.

*RST

IMM

Key Entry AM Sweep Times Coupled Off On

Key Entry Bus Free Run Ext Int Trigger Key

Agilent Technologies N5171B User Manual

Questions and Answers: