Agilent Technologies N5171B

176 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
:PMETer[1]|2:COMMunicate:USB:DEVice
Supported All Models
:SYSTem:PMETer[1]|2:COMMunicate:USB:DEVice <device>
:SYSTem:PMETer[1]|2:COMMunicate:USB:DEVice?
This command selects the USB device to be used for power meter measurements for Channel A or B.
The query returns the USB device identification.
Key Entry Connection Type > USB Devise
:PMETer[1]|2:COMMunicate:USB:LIST?
Supported All Models
:SYSTem:PMETer[1]|2:COMMunicate:USB:LIST?
This queries for the list of all connected USB devices.
:PMETer[1]|2:MEASure?
Supported All Models
:SYSTem:PMETer[1]|2:MEASure?
This query starts the measurement and returns the result for Channel A or B.
:PMETer[1]|2:SENSe:AVERage:COUNt
Supported All Models
:SYSTEm:PMETer[1]|2:SENSe:AVERage:COUNt <avgCount>
:SYSTEm:PMETer[1]|2:SENSe:AVERage:COUNt?
This command sets the averaging count value for Channel A or B when automatic averaging is
disabled (i.e. manual mode.) The query returns an integer.
Range: 1 to 2048
Key Entry Averaging Count
Default: 1024
:PMETer[1]|2:SENSe:AVERage:COUNt:AUTO
Supported All Models
:SYSTEm:PMETer[1]|2:SENSe:AVERage:COUNt:AUTO ON|OFF|1|0
:SYSTEm:PMETer[1]|2:SENSe:AVERage:COUNt:AUTO?
This command enables or disables the automatic averaging mode for Channel A or B. The query
returns the state of the automatic averaging mode.
Key Entry Averaging Mode
Default: Auto