Agilent X-Series Signal Generators SCPI Command Reference 325
Arb Commands
Multitone Subsystem–N5172B/82B ([:SOURce]:RADio:MTONe:ARB)
:SETup:TABLe:FSPacing
Supported N5172B/82B
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing <freq_spacing>
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing?
This command sets the frequency spacing between the tones.
The variable <freq_spacing> is expressed in units of Hertz (Hz–MHz).
*RST +1.00000000E+004
<freq_spacing> (>2 tones): 1E1 to (Option 65x bandwidth (num_tones 1))
Key Entry Freq Spacing
Remarks To set frequency spacing and additional parameters required to create or
configure a multitone waveform, refer to “:SETup:TABLe” on page 324.
This command is the second step in creating a multitone waveform. Refer to
“Creating a Multitone Waveform” on page 311 for all four steps.
:SETup:TABLe:NTONes
Supported N5172B/82B
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NTONes <num_tones>
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NTONes?
This command defines the number of tones in the multitone waveform.
*RST +8
Range 2 to 64
Key Entry Number Of Tones
Remarks To specify the number of tones and additional parameters required to create or
configure a multitone waveform, refer to “:SETup:TABLe” on page 324.
This command is the third step in creating a multitone waveform. Refer to
“Creating a Multitone Waveform” on page 311 for all four steps.
:SETup:TABLe:PHASe:INITialize
Supported N5172B/82B
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:PHASe:INITialize FIXed|RANDom
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:PHASe:INITialize?
This command initializes the phase in the multitone waveform table.
FIXed This choice sets the phase of all tones to the fixed value of 0 degrees.
RANDom This choice sets the phase of all tones to random values based on the setting on
the random seed generator.
*RST FIX
Range <freq_spacing> (2 tones): 1E1–Option 65x bandwidth
To Next Page
Loading...
Need help?
General
