Agilent X-Series Signal Generators SCPI Command Reference 201
Analog Modulation Commands
Amplitude Modulation Subsystem–Option UNT ([:SOURce])
:AM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP POSitive|NEGative
[:SOURce]:AM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP?
This command sets the ramp direction for the swept function generator when
:AM[1]|2:INTernal:SWEep:FUNCtion:SHAPe is set to RAMP.
*RST POS
:AM[1]|2:INTernal:SWEep:RATE[1]|2
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:RATE[1]|2 <val><units>
[:SOURce]:AM[1]|2:INTernal:SWEep:RATE[1]|2?
This command sets the sweep rate for the AM swept–sine waveform.
The sweep rate function is only available for internal source 1.
*RST +4.00000000E+002
Range 0.5 Hz to 100 kHz
Key Entry AM Sweep Rate
:AM[1]|2:INTernal:SWEep:SHAPe
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:SHAPe SAWTooth|TRIangle
[:SOURce]:AM[1]|2:INTernal:SWEep:SHAPe?
This command selects the sweep shape.
SAWTooth A sawtooth sweep shape only sweeps from start freq to stop freq.
TRIangle A triangle sweep sweeps from start freq to stop freq and back to start freq. With
a triangle shape sweep you can choose a different sweep rate for start freq to
stop freq and another sweep rate for stop freq to start freq.
*RST SAWTooth
:AM[1]|2:INTernal:SWEep:TIME:COUPled
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:TIME:COUPled ON|OFF|1|0
[:SOURce]:AM[1]|2:INTernal:SWEep:TIME:COUPled?
Key Entry Pos Ramp Neg Ramp
Key Entry AM Sweep Shape
To Next Page
Loading...
Need help?
General
