Agilent X-Series Signal Generators SCPI Command Reference 203
Analog Modulation Commands
Amplitude Modulation Subsystem–Option UNT ([:SOURce])
:AM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce TRIGger[1]|TRIGger2|PULSe
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce?
This command selects the external trigger source for the AM swept- sine waveform. With external
triggering, the selected bi- directional BNC is configured as an input.
TRIGger1 This choice selects the TRIG 1 BNC as the external trigger source for triggering
sweep, point and function generator sweeps.
TRIGger2 This choice selects the TRIG 2 BNC as the external trigger source for triggering
sweep, point and function generator sweeps.
PULSe This choice selects the PULSE BNC as the external trigger source for triggering
sweep, point and function generator sweeps.
*RST TRIGger1
:AM[1]|2:INTernal:SWEep:TRIGger:INTernal:SOURce
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:INTernal:SOURce PVIDeo|PSYNc
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:INTernal:SOURce?
This command selects the internal trigger source for the AM swept- sine waveform.
PVIDeo This choice selects Pulse Video as the internal trigger source for triggering sweep,
point and function generator sweeps.
PSYNc This choice selects Pulse Sync as the internal trigger source for triggering sweep,
point and function generator sweeps.
*RST PSYN
:AM[1]|2:INTernal:SWEep:TRIGger:SLOPe
Supported All Models with Options UNT and 303
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:SLOPe POSitive|NEGative
[:SOURce]:AM[1]|2:INTernal:SWEep:TRIGger:SLOPe?
This command sets the polarity of an external signal at the TRIG 1, TRIG 2, or PULSE BNC (see
:AM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce) or internal Pulse Video or Pulse Sync signal (see
:AM[1]|2:INTernal:SWEep:TRIGger:INTernal:SOURce) that will trigger a list or step sweep.
POSitive The signal generator triggers an event when it detects a rising edge on the source
signal
Key Entry Trigger 1 Trigger 2 Pulse
Key Entry Pulse Video Pulse Sync
To Next Page
Loading...
Need help?
General
