Agilent Technologies N5171B

310 Agilent X-Series Signal Generators SCPI Command Reference
Arb Commands
LARB Subsystem–N5172B/82B ([:SOURce]:RADio:LARB)
LARB Subsystem–N5172B/82B ([:SOURce]:RADio:LARB)
[:STATe]
Supported N5172B/82B
[:SOURce]:RADio:LARB[:STATe] ON|OFF|1|0
[:SOURce]:RADio:LARB[:STATe]?
This command enables or disables the waveform sweep function, when the signal generator is in list
sweep mode.
NOTE Except for the sample clock rate, unspecified fields in the header result in the default
settings of the dual arb’s settings being used (i.e. not the current arb’s settings). The sample
clock rate must be specified for the file header of the waveform file being played. If the
sample clock rate is unspecified in the file header, the instrument generates a header error.
*RST 0
Key Entry Waveform Off On
Remarks The Sweep Type softkey must be set to List for this command to function.