Agilent Technologies N5171B

Agilent X-Series Signal Generators SCPI Command Reference 187
System Commands
System Subsystem (:SYSTem)
:SSAVer:MODE
Supported All
:SYSTem:SSAVer:MODE LIGHt|TEXT
:SYSTem:SSAVer:MODE?
This command toggles the screen saver mode between light only or light and text.
LIGHt This choice enables only the light to turn off during the screen saver operation
while leaving the text visible on the darkened screen.
TEXT This choice enables both the display light and text to turn off during the screen
saver operation.
Key Entry Screen Saver Mode
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:SSAVer:STATe
Supported All
:SYSTem:SSAVer:STATe ON|OFF|1|0
:SYSTem:SSAVer:STATe?
This command enables or disables the display screen saver.
Key Entry Screen Saver Off On
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:TIME
Supported All
:SYSTem:TIME <hour>,<minute>,<second>
:SYSTem:TIME?
This command sets the time displayed in the lower right area of the signal generator’s display.
Key Entry Time/Date
:VERSion
Supported All
:SYSTem:VERSion?
This command returns the SCPI version number with which the signal generator complies.
Range <hour>: 0 to 23 <minute>: 0 to 59 <second>: 0 to 59