Agilent X-Series Signal Generators SCPI Command Reference 171
System Commands
System Subsystem (:SYSTem)
:LICense:[FPACk]:WAVeform:STATus?
Supported All Models
:SYSTem:LICense[:FPACk]:WAVeform:STATus? slot_number
This query returns the same values that are indicated in the Status column display.
:LICense:[FPACk]:WAVEform:USED?
Supported All Models
:SYSTem:LICense:FPACk:WAVEform:USED?
This query returns the number of slots used by licensed waveforms.
:LICense:INSTall
Supported All Models
:SYSTem:LICense:INSTall <license_line>|<block_of_license_lines>
This command installs the licenses into the signal generator.
Example
:SYST:LIC:INST "FEATURE 403 aspk 0 permanent 0 389D66FB107E9B02
HOSTID=N5182B,US00000068"
The preceding example installs license "FEATURE 403 aspk 0 permanent 0 389D66FB107E9B02
HOSTID=N5182B,US00000068", into the signal generator.
Example
:SYST:LIC:INST #210Qaz37pY9oL
The preceding is an example of the syntax for installing a block of licenses into the signal generator.
For more on handling block data, refer to the Programming Guide.
NOTE The data, Qaz37pY9oL, in the above command are not valid and are shown for example
purposes only. Typically, ASCII characters representing data are unprintable.
For additional information on downloading and installing licenses for applications, refer to
the Agilent License Manager at http://www.agilent.com/find/LicenseManager.
<license_line>
This choice installs a license line.
<block_of_license_lines>
This choice installs a block of license
lines.
To Next Page
Loading...
Need help?
General
