186 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
This command removes all user files, flatness correction files, and baseband generator files. In
addition, all table editor files are returned to their original factory values.
This command differs from the :DELete:ALL command, which does not reset table editors to factory
values. For more information about security functions, refer to the User’s Guide.
Key Entry Erase All
:SECurity:SANitize
Supported All Models
:SYSTem:SECurity:SANitize
This command removes all user files, table editor files values, flatness correction files, and baseband
generator files. The memory is then overwritten with a sequence of data as described below. For
more information about security functions, refer the User’s Guide.
SRAM All addressable locations will be overwritten with random characters.
HARD DISK All addressable locations will be overwritten with a single character and then a
random character.
FLASH MEMORY The flash blocks will be erased.
Key Entry Erase and Sanitize All
:SSAVer:DELay
Supported All
:SYSTem:SSAVer:DELay <value>
:SYSTem:SSAVer:DELay?
This command sets the amount of time before the display light or display light and text is switched
off. This will occur if there is no input through the front panel during the delay period.
The variable <value> is a whole number measured in hours.
Range 1 to 12
Key Entry Screen Saver Delay:
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
Refer to :SSAVer:MODE command for selecting the screen saver mode.
To Next Page
Loading...
Need help?
General
