Agilent X-Series Signal Generators SCPI Command Reference 61
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
[:SOURce]:SWEep:GENeration ANALog|STEPped
[:SOURce]:SWEep:GENeration?
This command sets the sweep type.
ANALog This choice selects an analog sweep.
STEPped This choice selects a step sweep.
Example
:SWE:GEN STEP
The preceding example selects a step sweep.
*RST STEP
Key Entry Sweep Type
:SWEep:POINts
Supported All Models
[:SOURce]:SWEep:POINts <value>
[:SOURce]:SWEep:POINts?
This command defines the number of step sweep points.
*RST 101
Range 2 to 65535
Key Entry # Points
:SWEep:SPACing
Supported All Models
[:SOURce]:SWEep:SPACing LINear|LOGarithmic
[:SOURce]:SWEep:SPACing?
This command enables the signal generator linear or logarithmic sweep modes. These commands
require the signal generator to be in step mode.
The instrument uses the specified start frequency, stop frequency, and number of points for both
linear and log sweeps.
*RST LIN
Key Entry Step Spacing LIN LOG
:SWEep:TIME
Supported All Models
[:SOURce]:SWEep:TIME <val><units>
[:SOURce]:SWEep:TIME?
To Next Page
Loading...
Need help?
General
