Agilent Technologies N5171B User Manual

Agilent X-Series Signal Generators SCPI Command Reference 369
Digital Signal Interface Module Commands
Digital Subsystem—Option 003 and 004 ([:SOURce])
:DIGital:DATA:OUTPut:SCALing
Supported N5172B/82B with option 003
:DIGital:DATA:OUTPut:SCALing <value>
:DIGital:DATA:OUTPut:SCALing?
This command enables scaling of the I and Q data to the level indicated by the <value> variable.
This command is valid for the N5102A output mode. The variable <value> is expressed as a
percentage.
Example
:DIG:DATA:OUTP:SCAL 50
The preceding example scales the I and Q data amplitude to 50%.
*RST +0.700000000E+002
Range 0 to 100
Key Entry
Scaling
:DIGital:DATA:OUTPut:SSI:BPFRam
Supported N5172B/82B with option 003 or 004 or both
:DIGital:DATA:OUTPut:SSI:BPFRam <value>
:DIGital:DATA:OUTPut:SSI:BPFRam?
This command sets how many bits of data are output between TXFS inputs for SSI output.
Example
:DIG:DATA:OUTP:SSI:BPRF 40
The preceding example sets the number of bits per frame to 40.
Range 1–64
Key Entry
SSI Output Bits Per Frame
:DIGital:DATA:OUTPut:SSI:SDELay
Supported N5172B/82B with option 003 or 004 or both
:DIGital:DATA:OUTPut:SSI:SDELay
:DIGital:DATA:OUTPut:SSI:SDELay?
This command sets the expected time between the DMCS output being asserted and the first TXFS
input (during which time the TXFS signal is ignored) for SSI output.
Example
:DIG:DATA:OUTP:SSI:SDEL 250
The preceding example sets the delay to 250 s.
Range 0s–648s
Key Entry
SSI Output Sync Delay

Agilent Technologies N5171B Specifications

General

Brand	Agilent Technologies
Model	N5171B
Category	Computer Hardware
Language	English