132 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Memory Subsystem (:MEMory)
non- volatile memory.
:DELete:ALL
Supported All Models
CAUTION Using this command deletes all non–volatile user files including binary, list, state, and
flatness correction files, and any saved setups which use the front- panel table editor.
However, this does not include files stored on the Option 653, 655, 656, or 657 ARB
generator. You cannot recover the files after executing this command.
:MEMory:DELete:ALL
This command clears the file system of all non–volatile user files.
Key Entry Delete All Files
:DELete:BINary
Supported All Models
:MEMory:DELete:BINary
This command deletes all binary files.
Key Entry Delete All Binary Files
:DELete:BIT
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:MEMory:DELete:BIT
This command deletes all bit files.
Key Entry Delete All Bit Files
•
"Shape_File" Shape_File is the shape data filename. The
directory path is not needed. The path
"/USER/SHAPE/" is implied.
• 6 Number of rise points describing the burst shape.
• 0,0.2,0.4,0.6,0.8,1.0 Rise point values.
• 2 Number of fall points describing the burst shape.
• 0.5,0 Fall point values.
Range num_rise_points: 2–256
num_fall_points: 2–256
rp0–rp(n): 0.0–1.0
fp0–fp(n): 0.0–1.0
To Next Page
Loading...
Need help?
General
