Agilent Technologies N5171B User Manual

Agilent X-Series Signal Generators SCPI Command Reference 223
Analog Modulation Commands
Low Frequency Output Subsystem ([:SOURce]:LFOutput)
:SWEep:FUNCtion:FREQuency:STOP
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:FUNCtion:FREQuency:STOP <val><units>
[:SOURce]:LFOutput:SWEep:FUNCtion:FREQuency:STOP?
This command sets the stop frequency for the swept function generator.
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry LF Out Stop Freq
:SWEep:FUNCtion:SHAPe
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:FUNCtion:SHAPe SINE|TRIangle|SQUare|RAMP
[:SOURce]:LFOutput:SWEep:FUNCtion:SHAPe?
This command sets the waveform type for the swept function generator.
*RST SINE
:SWEep:FUNCtion:SHAPe:RAMP
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:FUNCtion:SHAPe:RAMP POSitive|NEGative
[:SOURce]:LFOutput:SWEep:FUNCtion:SHAPe:RAMP?
This command sets the ramp direction for the swept function generator when
:SWEep:FUNCtion:SHAPe is set to RAMP.
*RST POS
:SWEep:RATE[1]|2
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:RATE[1]|2 <val><units>
[:SOURce]:LFOutput:SWEep:RATE[1]|2?
This command sets the sweep rate for the swept–sine waveform.
The sweep rate function is only available for internal source 1.
*RST +4.00000000E+002
Range 0.5 Hz to 100 kHz
Key Entry LF Out Sweep Rate
Key Entry LF Out Sweep Waveform
Key Entry Pos Ramp Neg Ramp

Agilent Technologies N5171B Specifications

General

Brand	Agilent Technologies
Model	N5171B
Category	Computer Hardware
Language	English