Agilent X-Series Signal Generators SCPI Command Reference 383
Real–Time Commands
Custom Subsystem–Option 431([:SOURce]:RADio:CUSTom)
“:BURSt:SHAPe:FTIMe” on page 383 performs the same function; in compliance
with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe:FDELay
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:FDELay <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:FDELay?
This command sets the burst shape fall delay.
The variable <val> is expressed in bits.
*RST
+0.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Fall Delay
Remarks
To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:FALL:DELay” on page 382 performs the same function; in
compliance with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
:BURSt:SHAPe:FTIMe
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:FTIMe <val>
[:SOURce]:RADio:CUSTom:BURSt:SHAPe:FTIMe?
This command sets the burst shape fall time.
The variable <val> is expressed in bits.
*RST
+5.00000000E+000
Range (depends on modulation type and symbol rate)
Key Entry Fall Time
Remarks To change the modulation type, refer to “:MODulation[:TYPE]” on page 392. Refer to
“:SRATe” on page 400 for a list of the minimum and maximum symbol rate values.
“:BURSt:SHAPe:FALL:TIME” on page 382 performs the same function; in
compliance with the SCPI standard, both commands are listed.
For concept information on burst shaping, refer to the User’s Guide.
To Next Page
Loading...