138 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Memory Subsystem (:MEMory)
:MEMory:STORe:LIST "<file name>"
This command stores the current list sweep data to a file.
Key Entry Store To File
:STORe:PTRain
Supported All with Option 320 and either UNU or UNW
:MEMory:STORe:PTRain <"filename">
Writes out the current pulse train list to the PTRAIN file specified. This operation will overwrite any
existing file of the same name in the PTRAIN directory with a binary file. Refer to :LOAD:PTRain.
Key Entry Store To File
:CATalog
Supported All Models
:MMEMory:CATalog? "<msus>"
This command outputs a list of the files from the specified file system.
The variable "<msus>" (mass storage unit specifier) represents "<file system>". The file systems and
types are shown in Table 1- 4 on page 15.
The return data will be in the following form:
<mem used>,<mem free>,"<file listing>"
The signal generator will return the two memory usage parameters and as many file listings as there
are files in the specified file system. Each file listing will be in the following format:
"<file name,file type,file size>"
Remarks Refer to MSUS (Mass Storage Unit Specifier) Variable for information on the use of
the "<msus>" variable.
:COPY
Supported All Models
:MMEMory:COPY "<file name>","<file name>"
This command makes a duplicate of the requested file.
Key Entry Copy File
Remarks Refer to File Name Variables for information on the file name syntax.
When copying a waveform file from volatile to non–volatile memory, the marker
file and file header, associated with the waveform file, will automatically be copied
at the same time.
Key Entry Binary List State User Flatness
Seq BBG Segments NVMKR NVWFM
To Next Page
Loading...
Need help?
General
