50 Agilent X-Series Signal Generators SCPI Command Reference
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
List/Sweep Subsystem ([:SOURce])
A complete sweep setup requires commands from other subsystems. Table 2- 2 shows the function
and location of these other commands.
:LIST:CPOint?
Supported All Models
[:SOURce]:LIST:CPOint?
Table 2-2 Location of Commands from the other Subsystems
Sweep Type Function Command Location Key Entry under
Sweep/List key
List and Step Configuring frequency sweep page 43 Freq Off On
Configuring amplitude sweep page 78 Amptd Off On
Configuring frequency and
amplitude sweep
a
a.Execute both commands to start or stop a frequency and amplitude sweep.
page 43
page 78
Freq & Amptd
Off On
Enables or Disables the
waveform sweep
page 310 Waveform Off On
Set up and control sweep
triggering
b
b.For point to point triggering, see “:LIST:TRIGger:SOURce” on page 56.
page 188 See the “Trigger
Subsystem”
List Load a list sweep file page 140 Load From Selected
File
Store list sweep data to a file page 137 Store To File
Selects the waveform for the
current waveform sequence
page 43
page 51
page 58
no softkey
List Sweep
Options Flags
This command enables
specific options during a list
sweep.
page 53 no softkey. Refer to
Table 2- 3 on
page 54
Step Start frequency sweep page 46 Freq Start
Store list sweep data to a file page 137 Store To File
Start amplitude sweep page 81 Amptd Start
Stop amplitude sweep page 81 Amptd Stop
To Next Page
Loading...
Need help?
General
