406 Agilent X-Series Signal Generators SCPI Command Reference
Real–Time Commands
Custom Subsystem–Option 431([:SOURce]:RADio:CUSTom)
:TRIGger[:SOURce]:EXTernal[:SOURce]
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom:TRIGger[:SOURce]:EXTernal[:SOURce] EPT1|EPT2|
EPTRIGGER1|EPTRIGGER2
[:SOURce]:RADio:CUSTom:TRIGger[:SOURce]:EXTernal[:SOURce]?
This command selects which PATTERN TRIG IN connection the signal generator uses to accept an
externally applied trigger signal when external is the trigger source selection.
For more information on configuring an external trigger source and to select external as the trigger
source, see “:TRIGger[:SOURce]” on page 404. For more information on the rear- panel connectors, see
the User’s Guide.
The following list describes the command choices:
EPT1
This choice is synonymous with EPTRIGGER1 and selects the PATTERN TRIG IN
rear-panel connector.
EPT2 This choice is synonymous with EPTRIGGER2 and selects the PATT TRIG IN 2 pin on
the rear-panel AUXILIARY I/O connector.
EPTRIGGER1 This choice is synonymous with EPT1 and selects the PATTERN TRIG IN rear-panel
connector.
EPTRIGGER2 This choice is synonymous with EPT2 and selects the PATT TRIG IN 2 pin on the
rear-panel AUXILIARY I/O connector.
*RST EPT1
[:STATe]
Supported N5172B/82B with Option 431
[:SOURce]:RADio:CUSTom[:STATe] ON|OFF|1|0
[:SOURce]:RADio:CUSTom[:STATe]?
This command enables or disables the Custom modulation.
*RST
0
Key Entry Custom Off On
Remarks Although the Custom modulation is enabled with this command, the RF carrier is
not modulated unless you also activate the front- panel
Mod On/Off hardkey.
Key Entry Patt Trig In 1 Patt Trig In 2
To Next Page
Loading...
Need help?
General
