Agilent X-Series Signal Generators SCPI Command Reference 51
Basic Function Commands
List/Sweep Subsystem ([:SOURce])
This query returns the current sweep point.
:LIST:DIRection
Supported All Models
[:SOURce]:LIST:DIRection UP|DOWN
[:SOURce]:LIST:DIRection?
This command sets the direction of a list or step sweep.
UP This choice enables a sweep in an ascending order:
• first to last point for a list sweep
• start to stop for a step sweep
DOWN This choice reverses the direction of the sweep.
*RST UP
Key Entry Sweep Direction Down Up
:LIST:DWELl
Supported All Models
[:SOURce]:LIST:DWEL1 <value>,<value>
[:SOURce]:LIST:DWEL1?
This command sets the dwell time for the current list sweep points.
Dwell time is used when IMMediate is the trigger source. Refer to the :LIST:TRIGger:SOURce
command for the trigger setting.
The dwell time is the amount of time the sweep is guaranteed to pause after setting the frequency
and/or power for the current point.
The setting enabled by this command is not affected by signal generator power–on, preset, or *RST.
The variable <value> is expressed in units of seconds with a 0.000001 (S).
NOTE The dwell time (<value>) does not begin until the signal generator has settled for the current
frequency and/or amplitude change.
Range 100E–6
:LIST:DWELl:POINts?
Supported All Models
[:SOURce]:LIST:DWELl:POINts?
This command queries the signal generator for the number of dwell points in the current list sweep
file.
To Next Page
Loading...
Need help?
General
