Agilent X-Series Signal Generators SCPI Command Reference 211
Analog Modulation Commands
Frequency Modulation Subsystem–Option UNT ([:SOURce])
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry FM Start Freq
:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP <val><units>
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STOP?
This command sets the stop frequency for the swept function generator.
*RST 400.0 Hz
Range 100 mHz to 6.250 MHz
Key Entry FM Stop Freq
:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe SINE|TRIangle|SQUare|RAMP
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe?
This command sets the FM waveform type for the swept function generator.
*RST SINE
:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP POSitive|NEGative
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe:RAMP?
This command sets the ramp direction for the swept function generator when
:FM[1]|2:INTernal:SWEep:FUNCtion:SHAPe is set to RAMP.
*RST POS
:FM[1]|2:INTernal:SWEep:RATE[1]|2
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:SWEep:RATE[1]|2 <val><units>
[:SOURce]:FM[1]|2:INTernal:SWEep:RATE[1]|2?
This command sets the sweep rate for the FM swept–sine waveform.
The sweep rate function is only available for internal source 1.
Key Entry FM Sweep Waveform
Key Entry Pos Ramp Neg Ramp
To Next Page
Loading...
Need help?
General
