Agilent Technologies N5171B

Agilent X-Series Signal Generators SCPI Command Reference 365
Digital Signal Interface Module Commands
Digital Subsystem—Option 003 and 004 ([:SOURce])
:DIGital:DATA:INPut:NOISe[:STATe]
Supported N5172B/82B with option 004
:DIGital:DATA:INPut:NOISe[:STATe] ON|OFF|1|0
:DIGital:DATA:INPut:NOISe[:STATe]?
This command enables or disables the real- time noise generator.
Example
:DIG:DATA:INP:NOIS[:STAT] ON
The preceding example enables the real- time noise generator.
*RST Off
Key Entry Real-Time AWGN Off On
:DIGital:DATA:IQSWap
Supported N5172B/82B with option 003 or 004 or both
:DIGital:DATA:IQSWap OFF|ON|0|1
:DIGital:DATA:IQSWap?
This command enables or disables swapping of the I and Q data. When enabled, the I data is sent to
the N5102A’s Q bus and the Q data is sent to the I bus.
Example
:DIG:DATA:IQSW ON
The preceding example enables swapping of I and Q data.
*RST 0
Key Entry
Swap IQ
:DIGital:DATA:NFORmat
Supported N5172B/82B with option 003 or 004 or both
:DIGital:DATA:NFORMat TCOMplement|OBINary
:DIGital:DATA:NFORMat?
This command selects the binary format used to represent the transmitted data values. The selections
are offset binary or 2’s complement.
Example
:DIG:DATA:NFOR OBIN
The preceding example selects the offset binary format to represent data values.
*RST TCOM
Key Entry
Numeric Format