364 Agilent X-Series Signal Generators SCPI Command Reference
Digital Signal Interface Module Commands
Digital Subsystem—Option 003 and 004 ([:SOURce])
In the other control modes, this will adjust the total power once for the specified channel noise
power level, after which the channel noise power could change if any noise parameters are adjusted.
The range varies based on the bounds of the total power that results from the noise settings.
The query returns the current noise power across the carrier bandwidth in dBm.
The variable <value> is expressed in units of dBm.
Example
:DIG:DATA:INP:NOIS:POW:NOIS:CHAN 0
The preceding example sets the channel noise power level to 0 dBm.
*RST 144
Range 144 to 30
Key Entry Channel Noise Power
To Next Page
Loading...