224 Agilent X-Series Signal Generators SCPI Command Reference
Analog Modulation Commands
Low Frequency Output Subsystem ([:SOURce]:LFOutput)
:SWEep:SHAPe
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:SHAPe SAWTooth|TRIangle
[:SOURce]:LFOutput:SWEep:SHAPe?
This command selects the sweep shape.
SAWTooth A sawtooth sweep shape only sweeps from start freq to stop freq.
TRIangle A triangle sweep sweeps from start freq to stop freq and back to start freq. With
a triangle shape sweep you can choose a different sweep rate for start freq to
stop freq and another sweep rate for stop freq to start freq.
*RST SAWTooth
:SWEep:TIME:COUPled
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:TIME:COUPled ON|OFF|1|0
[:SOURce]:LFOutput:SWEep:TIME:COUPled?
This command sets the couplings between start- to- stop values and stop- to- start values for
low- frequency output sweep times and rates. The sweep times coupled to on.
Use this command when :SWEep:SHAPe is set to TRIangle.
ON|1 This choice uses the same sweep time for both start freq to stop freq and stop
freq to start freq sweeps of a triangle shape sweep. If sweep times coupled is ON,
sweep time and rate is only set by the Start -> Stop softkeys.
OFF|0 This choice disables sweep time couplings.
*RST OFF
:SWEep:TIME[1]|2
Supported All Models with Options UNT and 303
[:SOURce]:LFOutput:SWEep:TIME[1]|2 <val><unit>
[:SOURce]:LFOutput:SWEep:TIME[1]|2?
This command sets the sweep time for the swept- sine waveform.
*RST
+1.00000000Eï€001
Range 1.0mS–65.535S
Key Entry LF Out Sweep Time
Key Entry LF Out Sweep Shape
Key Entry LF Out Sweep Times Coupled Off On
To Next Page
Loading...
Need help?
General
