184 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
System Subsystem (:SYSTem)
:SANalyzer:COMMunicate:LAN:PORT
Supported All Models
:SYSTem:SANalyzer:COM
Municate:LAN:PORT <portNum>
:SYSTem:SANalyzer:COMMunicate:LAN:PORT?
This command...
This command sets the IP port on the signal analyzer that is controlled by the signal generator.
Key Entry Signal Analyzer IP Port
5025 Standard mode. The command enables standard mode for simple programming.
5024 Telnet mode. The command enables the telnet SCPI service for programming.
NOTE For firmware versions <A.01.51, the default telnet mode is 5023. For firmware versions
A.01.51 and greater, telnet port 5023 is still available for backwards compatibility.
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
For more information on standard mode and telnet SCPI mode, refer to the
Programming Guide.
:SANalyzer:COMMunicate:TYPE
Supported All Models
:SYSTem:SANalyzer:COMMunicate:TYPE SOCKets|SOCKETS|VXI11
:SYSTem:SANalyzer:COMMunicate:TYPE?
This command sets the type of control connection for communication with the external signal
analyzer for spectral measurements. The query returns the connection type.
Key Entry Connection Type
SOCK or
SOCKETS The command enables the signal analyzer for sockets LAN control through the
signal generator.
VXI11 The command enables the signal analyzer for VXI–11 control through the signal
generator. A signal analyzer with GPIB can be controlled through VXI–11 using a
LAN–GPIB gateway.
USB The command enables the signal analyzer for USB control through the signal
generator.
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:SECurity:DISPlay
Supported All Models
:SYSTem:SECurity:DISPlay ON|OFF|1|0
:SYSTem:SECurity:DISPlay?
To Next Page
Loading...
Need help?
General
