To Next Page

To Previous Page

Agilent X-Series Signal Generators SCPI Command Reference 263

Arb Commands

Dmodulation Subsystem–N5172B/82B with Option 431 ([:SOURce]:RADio:DMODulation:ARB)

:PHASe:NOISe:TRACe?

Supported N5172B/82B with Option 431 and 432

[:SOURce]:RADio:DMODulation:ARB:PHASe:NOISe:TRACe?

This query returns the theoretical phase noise amplitude mask applied with the current settings if

the phase noise feature is on. This mask does not take the natural phase noise of the instrument into

account, only the impairment from the phase noise feature. The output is over the start frequency to

the stop frequency for the number of samples specified. The samples are taken at logarithmic

frequency steps and the output is in dBc/Hz.

:RETRigger

Supported N5172B/82B with Option 431

[:SOURce]:RADio:DMODulation:ARB:RETRigger ON|OFF|IMMediate

[:SOURce]:RADio:DMODulation:ARB:RETRigger?

This command enables or disables the ARB retriggering mode; the retrigger mode controls how the

retriggering function performs while a waveform is playing.

ON (1) This choice specifies that if a trigger occurs while a waveform is playing, the

waveform will retrigger at the end of the current waveform sequence and play

once more.

OFF (0) This choice specifies that if a trigger occurs while a waveform is playing, the

trigger will be ignored.

IMMediate This choice specifies that if a trigger occurs while a waveform is playing, the

waveform will reset and replay from the start immediately upon receiving a

trigger.

*RST ON

:SCLock:RATE

Supported N5172B/82B with Option 431

[:SOURce]:RADio:DMODulation:ARB:SCLock:RATE <val>

[:SOURce]:RADio:DMODulation:ARB:SCLock:RATE?

This command sets the sample clock rate.

The variable <val> is expressed in units of Hertz (kHz  MHz)

*RST +4.00000000E+006

Range 1E3 to 2E8

Key Entry ARB Sample Clock

Range <startFreq> 1 Hz to 100 MHz

<stopFreq> 1 Hz to 100 MHz

<numSamples> 1 to 8192

Key Entry On Off Immediate

Agilent Technologies N5171B User Manual

Questions and Answers: