To Next Page

To Previous Page

Agilent X-Series Signal Generators SCPI Command Reference 213

Analog Modulation Commands

Frequency Modulation Subsystem–Option UNT ([:SOURce])

Range 1.0mS–65.535S

Key Entry FM Sweep Time

:FM[1]|2:INTernal:SWEep:TRIGger

Supported All Models with Options UNT and 303

[:SOURce]:FM[1]|2:INTernal:SWEep:TRIGger?

This command sets the trigger source for the frequency modulated swept- sine waveform.

BUS This choice enables GPIB triggering using the *TRG or GET command or LAN and

RS- 232 triggering using the *TRG command.

IMMediate This choice enables immediate triggering of the sweep event.

EXTernal This choice enables the triggering of a sweep event by an externally applied signal

at the TRIG 1, TRIG 2, or PULSE BNC connector.

INTernal This choice enables the triggering of a sweep event by an internal Pulse Video or

Pulse Sync signal.

KEY This choice enables triggering through front panel interaction by pressing the

Trigger hardkey.

*RST

IMM

:FM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce

Supported All Models with Options UNT and 303

[:SOURce]:FM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce TRIGger[1]|TRIGger2|PULSe

[:SOURce]:FM[1]|2:INTernal:SWEep:TRIGger:EXTernal:SOURce?

This command selects the external trigger source for the FM swept- sine waveform. With external

triggering, the selected bi- directional BNC is configured as an input.

TRIGger1 This choice selects the TRIG 1 BNC as the external trigger source for triggering

sweep, point and function generator sweeps.

TRIGger2 This choice selects the TRIG 2 BNC as the external trigger source for triggering

sweep, point and function generator sweeps.

PULSe This choice selects the PULSE BNC as the external trigger source for triggering

sweep, point and function generator sweeps.

*RST TRIGger1

Key Entry Bus Free Run Ext Int Trigger Key

Key Entry Trigger 1 Trigger 2 Pulse

Agilent Technologies N5171B User Manual

Questions and Answers: