Agilent X-Series Signal Generators SCPI Command Reference 95
3 System Commands
This chapter provides SCPI descriptions for subsystems dedicated to peripheral signal generator
operations common to all Agilent MXG models.
This chapter contains the following major sections:
• Calibration Subsystem (:CALibration) on page 96
• Communication Subsystem (:SYSTem:COMMunicate) on page 100
• Diagnostic Subsystem (:DIAGnostic[:CPU]:INFOrmation) on page 105
• Display Subsystem (:DISPlay) on page 108
• IEEE 488.2 Common Commands on page 112
• Memory Subsystem (:MEMory) on page 117
• Output Subsystem (:OUTPut) on page 143
• Route Subsystem (:ROUTe) on page 145
• Status Subsystem (:STATus) on page 153
• System Subsystem (:SYSTem) on page 164
• Trigger Subsystem on page 188
• Unit Subsystem (:UNIT) on page 193
To Next Page
Loading...
Need help?
General
