Agilent Technologies N5171B User Manual

98 Agilent X-Series Signal Generators SCPI Command Reference
System Commands
Calibration Subsystem (:CALibration)
:IQ:STARt
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:CALibration:IQ:STARt <value><unit>
:CALibration:IQ:STARt?
This command sets the start frequency and automatically sets the calibration type to User for an I/Q
calibration.
The start frequency must be less than the current value of the stop frequency.
Key Entry Start Frequency
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:IQ:STOP
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:CALibration:IQ:STOP <value><unit>
:CALibration:IQ:STOP?
This command sets the stop frequency and automatically sets the calibration type to User for an I/Q
calibration.
The stop frequency must be greater than the current value of the start frequency.
Key Entry Stop Frequency
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
:IQ:TYPE
Supported N5172B with Option 653 or 655, N5182B with Option 656 or 657
:CALibration:IQ:TYPE DC|USER|FULL
:CALibration:IQ:TYPE?
This command sets the IQ calibration type.
Key Entry Calibration Type DC User Full
Remarks The setting enabled by this command is not affected by signal generator power–on,
preset, or *RST.
Range Option 503: 5 MHz to 3 GHz
Option 506: 5 MHz to 6 GHz
Range Option 503: 5 MHz to 3 GHz
Option 506: 5 MHz to 6 GHz

Agilent Technologies N5171B Specifications

General

Brand	Agilent Technologies
Model	N5171B
Category	Computer Hardware
Language	English