210 Agilent X-Series Signal Generators SCPI Command Reference
Analog Modulation Commands
Frequency Modulation Subsystem–Option UNT ([:SOURce])
*RST 0.000 rad
:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe
Supported All Models with Option UNT
[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe SINE|SQUare|RAMP|PULSe
[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe?
This command sets the FM waveform type.
*RST SINE
Remarks The waveform selection is only valid when INT is the source selection. Refer to
“:FM[1]|2:SOURce” on page 214 for source type selection.
SINE is the only shape available without Option 303.
:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP POSitive|NEGative
[:SOURce]:FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe:RAMP?
This command sets the ramp direction when :FM[1]|2:INTernal:FUNCtion[1]|2:SHAPe is set to RAMP.
*RST POS
:FM[1]|2:INTernal:NOISe[1]|2:TYPe
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:NOISe[1]|2:TYPe UNIForm|GAUSsian
[:SOURce]:FM[1]|2:INTernal:NOISe[1]|2:TYPe?
This command sets the noise type when “:FM[1]|2:SOURce” on page 214 is set to NOISe[1] or
NOISe2.
*RST POS
:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt
Supported All Models with Options UNT and 303
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt <val><units>
[:SOURce]:FM[1]|2:INTernal:SWEep:FUNCtion:FREQuency:STARt?
This command sets the start frequency for the swept function generator.
Range - 6.290 to 6.290 rad
- 360.4 to 360.4 deg
Key Entry FM Phase Offset
Key Entry Pos Ramp Neg Ramp
Key Entry Noise Gen 1 Noise Gen 2
To Next Page
Loading...
Need help?
General
