Benelli TNT125 Service Manual

Preparation Information
Overview
The crankcase is a thin-wall casting and shall be
protected against impact during operation to avoid
deformation or damage.
All parts should be rinsed and cleaned by using
high-pressure air before inspection and measurement.
The lubricant in the crankcase should be discharged
before operation.
This section mainly introduces the disassembly
and installation of parts of crankcase, torque value of
bolt specifications, notes for disassembly and
installation and other services;
Technical Parameters
Torque Value
Assembling bolt 10 N•m Apply oil
Main chain guide screw
10 N•m
Apply locking agent
Gear position sensor 10 N•m Apply oil
Oil filter screw plug 20 N•m Apply oil
Retainer screw 7 N•m Apply oil
- 236 -

Benelli TNT125 Specifications

General

Displacement	125 cc
Transmission	5-speed
Fuel System	EFI
Fuel Capacity	7.2 liters
Seat Height	780 mm
Dry Weight	116 kg
Bore x Stroke	54 mm x 54.5 mm
Starting System	Electric
Wheelbase	1215 mm
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Suspension	Upside-down fork
Front Brake	Single disc
Rear Brake	Single disc
Front Tire	120/70-12
Rear Tire	130/70-12
Max Power	8.2 kW (11.1 Cv) @ 9500 rpm
Rear Suspension	Swing arm with lateral shock absorber with adjustable spring preload