Benelli TNT125 - Cable Connector Check; Disconnection; Check

Cable Connector Check
Make sure that there are no corrosion, moisture
and other foreign matters on the connector.
1. Disconnection
 Wire
 Connector
 Joint
2. Check
 Wire
 Connector
 Joint
If there are moisture traces, use the compressed air
to dry it.
If there is corrosion, plug the connection parts for
several times or use the rust remover, and replace
the parts with serious corrosion timely.
3. Check
 All connectors
 If any joint is loose, conduct correct connection
again.
Note
If the “A” pin on the terminal is flat, please bend it.
- 28 -