Cable Arrangement
Loose cable is a potential electrical safety hazard.
Check the latter cable after the cable is clamped to
ensure the electrical safety;
It is not allowed to bend the cable clamp in the
direction of welding spot;
Bind the cables at the specific position;
It is not allowed to arrange the cables at the end
of frame or at the position of sharp corner;
It is not allowed to arrange the cables at the end
of bolts or screws;
The position of heat source or the position where
the cables may be clamped shall be avoided during
cable arrangement;
The cables shall not be pulled too tightly or too
loosely and shall not interfere with any adjacent part in
any turning position when they are arranged along the
faucet handle;
The cables shall be arranged smoothly without
distortion or tangle;
Make sure whether the connector sheath is
damaged or whether the connector is opened
excessively before the connector is docked.
If the cable is at the position of sharp corner or
corner, please protect it with tape or hose;
After the cable is repaired, bind up the bare parts
reliably with tape;
The control cables shall not be bent or twisted. If
the control cables are damaged, the manipulation will
not be flexible;
Tool
In order to make the measurement results
accurate, the instrument with accurate scale shall be
used. Read the instructions provided by the
manufacturer carefully before using the instrument.
Inaccurate measured values may affect the adjustment
results.
- 30 -
To Next Page
Loading...
Need help?
General
