Benelli TNT125 Service Manual

Checking Fuel Hose (Fuel Leakage, Hose Break and Hose Installation Situations)
○
If the motorcycle is not handled properly, the high
pressure inside the fuel pipe may lead to fuel leakage
[A] or fuel pipe break. Remove the fuel tank (see “Fuel
Tank Disassembly” in the “Fuel Injection System
(EFI)” chapter) and check the fuel pipe.
★If any wear, crack [B] or expansion [C] is found, the
fuel pipe must be replaced.
●Check whether the winding method of hose meets the
relevant specifications of the “Winding Method of
Cable, Wire and Hose” section of the “Accessory”
chapter.
★
If the hose is bent or broken seriously, it needs to
be replaced.
Hose joint [A]
Fuel pipe [B]
●Check whether the connection of hose joint is firm.
○
Push and pull the hose joint [A] for more than twice
to ensure that the hose joint is fixed firmly.
★
If the connection is not firm, install the hose joint
again.
Warning
Slide the joint to ensure that the hose joint is
properly installed on the fuel supply pipe,
otherwise the fuel leakage may occur.
- 58 -

Benelli TNT125 Specifications

General

Displacement	125 cc
Transmission	5-speed
Fuel System	EFI
Fuel Capacity	7.2 liters
Seat Height	780 mm
Dry Weight	116 kg
Bore x Stroke	54 mm x 54.5 mm
Starting System	Electric
Wheelbase	1215 mm
Engine Type	Single cylinder, 4-stroke, air-cooled
Front Suspension	Upside-down fork
Front Brake	Single disc
Rear Brake	Single disc
Front Tire	120/70-12
Rear Tire	130/70-12
Max Power	8.2 kW (11.1 Cv) @ 9500 rpm
Rear Suspension	Swing arm with lateral shock absorber with adjustable spring preload